On your out lap (1st lap time on track) on the track perform a few near stops. This will get the two surfaces (disc and pad) to mate up and put down a transfer layer into the micro-grooves on the discs. Then, drive like normal
Read More
Do discs require a bedding process?
Brake discs do not require a detailed procedure as brake pads require. By following the brake pad bed-in procedure will result in your discs being completely bedded. If you purchase pre-bedded pads from G-Loc™ then all you need to do is install the pads and
Read More
How do I clean or resurface my used discs/rotors?
If you have another manufacturers brake pad materials on your discs, then you definitely need to clean them up or get them turned by a professional before installing G-Loc™ brake pads. To clean your discs, use a power sander with no less than 80 grit
Read More
Do I need to get new discs/rotors?
Although a good idea, you don’t have to start with new brake pads and new discs. If you want to keep your current discs, then you need to clean them up (see below).
Read More
Why should I bed-in brake pads?
Proper bedding of pads & discs will result in greater performance and longer pad life along with improved disc/disc wear. Failure to properly bed in your pads will lead to increased wear of the pads. It can also lead to glazing of both the pads
Read More